Materials
that we need :
1)
Lamp
2)
Cable (for about 2 meters)
3)
Fitting= lampshade
4)
Plastic jar
5)
Sakelar
6)
Sticker=biting
The
Procedures:
1)
Prepare the materials
2)
Peel each edge of the cable so we can
get the copper inside it.
3)
In the edge down side of the jar,
make a small hole so the cable can go out from the jar and it can connect with
sakelar and sticker
4)
Connect the edge of the cable that we
already peel with the down side of the lampshade.
5)
Open the lid of the jar and put a
lampshade that has been connected with the cable. Pull the cable in the small
hole in the down side of the jar (that we have already made in step 3)
6)
After that, we see the bottom of the
jar. Mark two dots with board marker. Then, turn the bolds (baut) in the lamp
shade with screwdriver until it cut through (menembus) the bottom of the jar.
7)
Put the lamp into the lampshade
8)
Connect the other edge of the cable
with sakelar. To connect it, we just need one cable.
9)
Test it with AVO meter
10) Connect the cable
with sticker(biting)
11) Test the lamp
12) Make two holes in
the jar in the different side to make a hanger
13) Use wire to make
the hanger, enter the wire into the hole and warped it.
